The assembly or AICAR mouse adsorption process was monitored by measuring the frequency change of the QCM selleckchem resonator. Figure 1 Schematic

drawing of the pythio-MWNT SAMs and adsorption of Cyt c. Generally, the assembly of organic molecules such as viologenthiol derivatives on the gold surface could be completed within several hours [19, 20]. During the experiments, we found that formation of the present pythio-MWNT SAMs took quite a long time (over 10 h); thus, we measured the frequency change of the QCM resonators before and after the assembly instead of recording the whole dynamic assembling process. A possible reason for such a slow assembly was the fact that the pythio-MWNT hybrids were nanomaterials with a ‘molecular weight’ much larger than that of the commonly used organic molecules; thus, both the Au-S bond formation and ‘molecules’ (pythio-MWNT hybrids) moving in

the solution were very slow. The frequency change (ΔF) was about 4.88 kHz after formation of the pythio-MWNT SAMs. Based on the equation of ΔF = −2F 0  2 Δm/(A ρ q  1/2 μ q  1/2), where F 0 is the fundamental resonant frequency (9 MHz), Δm (g) is the mass change, A is the surface area (0.196 cm2) of the QCM resonator, ρ q is the density of the quartz (2.65 g/cm3), and μ q is the shear module (2.95 × 1011 dyne/cm2) [21], the mass change was about 5.2 μg/cm2. After composition and morphology characterization of the pythio-MWNT SAMs (as to be described below), the

SAMs were immersed in the Cyt c solution to form pythio-MWNT-Cyt c bio-nanocomposites, the adsorption process of which this website was also monitored by using QCM. Figure 2 shows the frequency change ΔF as a function of time (t) for the SAMs of pythio-MWNTs immersed in the 2 mg/ml solution Cyt c. The curve indicated that the frequency decreased quickly at the initial 10 min, then this decrease became slower and slower (a platform-like stage was observed). After about 40 min, the frequency did not show an obvious decrease, and a platform was formed. Figure 2 Frequency change with adsorption time for the pythio-MWNTs SAMs in the Cyt c solution. This ΔF t curve suggested that adsorption of the Cyt c on the SAMs of pythio-MWNTs was very quick at the initial 10 min and then became slower to reach an equilibrium state between adsorption and desorption. The whole Levetiracetam assembly could be completed within 1 h. During the adsorption of the proteins on the surface of the SAMs, a platform-like stage may indicate that the adsorption was very quick at the ‘naked’ SAM surface. Then, two processes may dominate the adsorption: one was the equilibrium state between adsorption and desorption and the other one may be the formation of double layers. Based on the ΔF value, we calculated that the amount of the Cyt c adsorbed was about 0.29 μg/cm2. Since the molecular weight of Cyt c was about 11,000~13,000, the surface density of the Cyt c was about 0.22~0.26 × 10−10 mol/cm2.