This makes it difficult to identify the target bacteria using the Raman technique without a separation procedure. On the other hand, a pure SERS see more signature of bacteria was obtained by directing a laser spot at the bacteria aggregate separated from the blood cells after applying a predetermined separation and trapping condition. Figure  5c shows very distinct fingerprints of S. aureus and P. aeruginosa that were measured after separation and AgNP-bacteria sorption from a bacteria-blood mixture. The background was measured from the diluted human blood without any bacteria after electrokinetically trapping both the blood cells and bacteria on the electrode edges at a frequency GSK2126458 concentration of 5 MHz. The

results show that this technique can be used to trap bacteria from a sample containing blood cells, that its Raman signal can be enhanced via AgNP-bacteria sorption Selleckchem Tipifarnib to determine the presence of blood infections, and that it can carry out on-chip identification of bacteria in bacteremia by comparing the detected SERS spectra to the spectra library. This method offers a number of potential advantages over conventional methods for cell/bacteria/virus identification, including extremely rapid speed, low cost for each detection, and simple process requirements. Figure 5 Separation and concentration of bacteria, SERS spectra,

and detection result. (a) Separation and concentration of bacteria from a BC-bacteria mixture. Inset A1 shows a higher magnification photo of the center area; there

is a high density of bacteria aggregate buy Ponatinib without blood cells at the center. (b) The SERS spectra of RBC, RBC-bacteria mixture, and the S. aureus dielectrokinetically separated from blood. (c) The detection result shows very distinct fingerprints of S. aureus and P. aeruginosa that were measured after separation and AgNP-bacteria sorption. Conclusions A novel mechanism for dielectrophoretic trapping of nanoscale particles through the use of a microparticle assembly was demonstrated for the purpose of effectively trapping nanocolloids using the amplified positive DEP force. The amplified electric field is shown to be 2 orders higher than the original middle region, and thus, the DEP force at these local regions can be predicted as 4 orders higher. The appropriate design for this trapping mechanism is one in which the gaps of quadruple electrodes are smaller than 50 μm in order to achieve a sufficient electric field strength needed for manipulating nanocolloids using the amplified positive DEP force. This mechanism was also used for SERS identification of bacteria from diluted blood successfully. The bacteria and blood cells were separated employing their different DEP behaviors, and furthermore, the concentrated bacteria produced an amplified positive DEP force for adsorption of AgNPs on the bacteria surface. The enhancement of SERS was at least 5-fold higher at an optimal AgNP concentration of 5 × 10-7 mg/μl when compared with the normal Raman spectrum.